JCB 802 802.4 802 Super Mini Excavator Factory Workshop Service Manual 9803/3140 - preview 1

JCB 802 802.4 802 Super Mini Excavator Factory Workshop Service Manual 9803/3140

$25.00
Skip to product information
JCB 802 802.4 802 Super Mini Excavator Factory Workshop Service Manual 9803/3140 - preview 1

JCB 802 802.4 802 Super Mini Excavator Factory Workshop Service Manual 9803/3140

$25.00

JCB 802 802.4 802 Super Mini Excavator Factory Workshop Service Manual 9803/3140

A digital technical reference for your equipment.

Manual details

  • Brand / equipment: JCB
  • Manual type: Workshop / Service Manual
  • File size: 20.13 MB
  • Pages: 293
  • File format: PDF
  • Language: English

Contents listed in this manual

  • training by JCB Technical Training Department.
  • 1 = General Information - includes torque settings and service tools
  • 2 = Care & Safety - includes warnings and cautions pertinent to aspects of workshop procedures etc.
  • Routine Maintenance - includes service schedules and recommended lubricants for the machine.
  • example:
  • A = Attachments
  • B = Body & Framework ... etc.
  • rapid reference.
  • can be reversed for assembly.
  • dry threads, hence for lubricated threads may be reduced by one third.
  • General Information
  • Identification
  • Storing the machine 1 - 2ROPS, TOPS and FOGS
  • Track controls 3 - 2Engine controls 3 - 3Switches 3 - 4Instruments
  • Dozer controls 4 - 1Excavator controls
  • Service Tools
  • Sealing and Retaining Compounds
  • STORAGE
  • Preparation for Storage
  • The operations to place a machine into storage
  • (-15oC to 44o C) are given below.
  • 2Switch off the engine. Operate controls to releasepressure from the rams.
  • 3Disconnect battery to prevent discharge.
  • 4Ensure the fuel tank is filled to a maximum, leavingno air space.
  • 5Ensure hydraulic tank is filled to maximum on thesight gauge.
  • 6Spray exposed ram rods with Waxoyl.
  • 7Slacken off rubber tracks until no visible spring
  • tension exists.Preparation after Storage
  • The operations to remove a machine from storage
  • (-15oC to 44o C) and prepare it for use are given below.
  • 1Lower the fuel level to ensure that sufficient air spaceexists in the tank.
  • 3Ensure the battery is fully charged.
  • 4Reconnect battery.
  • 5Remove electrical contact from fuel injection pumpsolenoid.
  • 6Crank engine for 15 seconds or until oil pressurewarning light goes out.
  • 7Reconnect electrical supply to the fuel injectionpump solenoid.
  • 8Start the engine. If the engine fails to start afterseveral attempts, bleed the fuel system.
  • 9Adjust track tensions.
  • 10Grease all lubrication points.1 -

Before you order

Check the model, edition, serial-number coverage and real preview pages against your equipment.

Digital product

Digital manual only. No printed book or physical item will be shipped.

You may also like